| Enable/Disable front stairs | Enables/disables front stair. When used while in automatic mode, overrides the automatic settings until reset. |
| Enable/Disable aft stairs | Enables/disables aft stair. When used while in automatic mode, overrides the automatic settings until reset. |
| Enable/Disable line maintenance van | Enables/disables line maintenance van and workers. When used while in automatic mode, overrides the automatic settings until reset. |
| Enable/Disable integrated airstairs | Enables/disables integrated airstairs. This function is available for the X-Plane's default B737-800. |
| Auto-enable ground equipment | Toggles automatic functions. When turned on, the equipment selected in the settings submenu is automatically activated. Activation conditions are described in the next tab. |
| Auto-enable settings | Submenu for configuring automated mode. Not every option is available with every aircraft. |
| Auto-enable status: | Show the status of the automatic system. When no overrides are active, this menu item is disabled and only notifies that the system works OK. If any of the overrides is active, this menu item becomes enabled and the status changes to Manual override (press to reset). In such case the menu item can be used to reset the automated system to the state defined by the settings from the Auto-enable settings submenu (for override notification see the picture below). |
| Reposition on aircraft position change | When this option is turned on, all the equipment repositions with the aircraft when moved, eg. using the map view. If turned off, all the enabled equipment is disabled when the aicraft is moved and must be enabled again.
中文
[td]用法 | 插件的所有功能都由插件菜单控制。菜单的结构如下图所示。 |
|
|
| 职能 | 启用/禁用前楼梯 启用/禁用前楼梯。在自动模式下使用时，覆盖自动设置直到重置。 | 启用/禁用后楼梯 启用/禁用后楼梯。在自动模式下使用时，覆盖自动设置直到重置。 | 启用/禁用线路维护车 启用/禁用线路维护车和工人。在自动模式下使用时，覆盖自动设置直到重置。 | 启用/禁用集成楼梯 启用/禁用集成楼梯。此功能适用于 X-Plane 的默认 B737-800。 | 自动启用地面设备 切换自动功能。打开后，在设置子菜单中选择的设备会自动激活。激活条件在下一个选项卡中描述。 | 自动启用设置 用于配置自动化模式的子菜单。并非每架飞机都提供所有选项。 | 自动启用状态：显示自动系统的状态。当没有覆盖处于活动状态时，此菜单项被禁用并且仅通知系统工作正常。如果任何覆盖处于活动状态，此菜单项将变为启用状态，并且状态更改为手动覆盖（按下以重置）。在这种情况下，菜单项可用于将自动化系统重置为自动启用设置子菜单中的设置定义的状态（覆盖通知见下图）。 |
|
| 飞行器位置改变时重新定位 当该选项打开时，所有设备在移动时与飞行器一起重新定位，例如。使用地图视图。如果关闭，当飞行器移动时所有启用的设备都被禁用，必须再次启用。[/td] |
默认
首页
